Surface

MNM Fatality – 3/1/23

renewcomerLeave a comment

On March 1, 2023, a miner died when the bulldozer he was operating went over an embankment, ejecting him from the operator’s cab.

Best Practices

Operators should train miners to:

  • Wear a seat belt while operating mobile equipment. 
  • Examine ground conditions before beginning work in an area and as ground conditions warrant during the work shift.  
  • Operate equipment safely, and to identify and report hazards.
  • Be aware of their position relative to edges of roadways and benches.

Additional Information

This is the tenth fatality reported in 2023, and the third classified as “Machinery.”

Click here for: Preliminary Report (pdf), Final Report (pdf).

MNM Fatality – 1/17/23

renewcomerLeave a comment

On January 17, 2023, a miner was fatally injured when his personal car collided with a customer truck. Both vehicles were traveling toward each other in opposite directions on an icy mine access road.

Best Practices

Operators should:

  • Clear roadways of ice and snow or require traction devices to assure safe operation of mobile equipment.
  • Alert drivers to reduce speed on wet or icy roads. 
  • Maintain control of equipment while it is in operation.

Additional Information

This is the second fatality reported in 2023, and the first classified as “Powered Haulage.”

Click here for: Preliminary Report (pdf), Final Report (pdf).

MNM Fatality – 12/16/22

renewcomer1 Comment

On December 16, 2022, a contract mechanic died while removing the counterweight of an excavator, when it fell and struck him.

Best Practices

Operators should:

  • Block machinery components against motion before beginning maintenance or repairs.
  • Assure blocking material is substantial and installed correctly to support and stabilize the load.
  • Assure miners position themselves in a safe location and away from potential pinch point areas.
  • Train miners to conduct repairs according to manufacturer recommendations.

Additional Information

This is the 29th fatality reported in 2022, and the tenth classified as “Machinery.”

Click here for: Preliminary Report (pdf), Final Report (pdf).

MNM Fatality – 1/4/23

renewcomerLeave a comment

On January 4, 2023, a miner was fatally injured while performing maintenance inside a jaw crusher. The pitman assembly (moving jaw) rotated, pinning the miner against the crusher housing.

Best Practices

Operators should:

  • block machinery components against motion before beginning maintenance or repairs;
  • position miners in a safe location and away from potential pinch point areas;
  • conduct repairs according to manufacturer’s recommendations; and
  • develop procedures for working safely in confined spaces.

Additional Information

This is the first fatality reported in 2023, and the first classified as “Machinery.”

Click here for: Preliminary Report (pdf) Final Report (pdf).

MNM Fatality – 11/5/22

renewcomerLeave a comment

On November 5, 2022, a miner died when he was engulfed in a coal stockpile at a cement operation.

Best Practices

  • Equip grates and feeders with mechanical clearing devices to prevent miners from being exposed to hazards of falling or sliding material.
  • Make sure miners do not travel by foot on stockpiles or near the toe of stockpile slopes.
  • Make sure miners can be seen, heard, or can communicate with others when working alone under hazardous conditions. 
  • Examine working places to identify the potential for falling or sliding materials prior to allowing access to areas in or around grates and feeders.

Additional Information

This is the 27th fatality reported in 2022, and the third classified as “Engulfment.”

Click here for: Preliminary Report (pdf), Final Report (pdf).

MNM Fatality – 10/17/22

renewcomerLeave a comment

On October 17, 2022, a miner died when he fell approximately 90 feet from the walkway outside the plant’s mill building.

Best Practices

  • Train miners to be aware of fall hazards in their workplace.
  • Provide and maintain safe access to areas where miners work or travel.

Additional Information

This is the 25th fatality reported in 2022, and the third classified as “Slip or Fall of Person.”

Click here for: Preliminary Report (pdf)

Investigation determined that the fatality was not chargeable to mine operator.

MNM Fatality – 10/7/22

renewcomerLeave a comment

On October 7, 2022, a mechanic was fatally injured when he was engulfed in material after he entered an air separator to clear a blockage. 

Best Practices: 

  • Install mechanical flow-enhancing devices, such as mechanical vibratory devices, that can maintain material flow and prevent the need for miners to enter a confined space.
  • Mine operators should establish procedures to clear blockages and train all miners in the procedures.
  • Make sure miners wear a safety belt or harness equipped with a lifeline when entering a confined space, and that a second miner, similarly equipped, is attending the lifeline.

Additional Information: 

This is the 24th fatality reported in 2022, and the first classified as “Confined Space.”

Click here for: Preliminary Report (pdf), Final Report (pdf).

MNM Fatality – 10/1/22

renewcomerLeave a comment

On October 1, 2022, a miner died while using a crane to remove a haul truck engine.  The auxiliary line broke, causing the hook and ball assembly to fall and strike the miner.

Best Practices: 

  • Make sure cranes have functional anti-two blocking devices to automatically shut off the crane when the rigging on the hoist line gets close to the sheave at the end of the crane boom.
  • Make sure miners stay clear of suspended loads and use taglines when necessary for steadying or guiding suspended loads.
  • Make sure miners conduct thorough pre-operational inspections of all machinery, equipment, and tools prior to use.

Additional Information: 

This is the 23rd fatality reported in 2022, and the eighth classified as “Machinery.”

Click here for: Preliminary Report (pdf), Final Report (pdf).

MNM Fatality – 9/28/22

renewcomerLeave a comment

On September 28, 2022, a miner died when he was engulfed in a collapsed stockpile.  The miner was working close to the toe of the stockpile to remove material off the top of a surge tunnel’s feeder to clear a blockage.

Best Practices: 

  • Operators should have procedures to safely clear blockages from feeders, and train miners to stay out of areas where there is a danger of falling or sliding material.
    • Equip feeders with mechanical clearing devices to prevent exposing miners to hazards of falling or sliding material.
  • Make sure miners trim stockpiles to prevent hazards.

Additional Information: 

This is the 22nd fatality reported in 2022, and the first classified as “Engulfment.”

Click here for: Preliminary Report (pdf), Final Report (pdf).

MNM Fatality 8/4/22

renewcomerLeave a comment

On August 4, 2022, a mine manager died while performing maintenance on a bulldozer.  While kneeling on the bulldozer’s track, the victim accidentally engaged the lever that put the bulldozer in reverse.  The bulldozer track moved the victim to the rear of the bulldozer where he was run over.

Best Practices: 

  • Operators should train miners on safe maintenance procedures:
    • turn off the engine
    • block equipment against motion
  • Operators should make sure miners are in a safe location in relation to machine parts that can move.

Additional Information: 

This is the 17th fatality reported in 2022, and the seventh classified as “Machinery.”

Click here for: Preliminary Report (pdf), Final Report (pdf).