On October 31, 2017, a 340-ton haul truck ran over a passenger van carrying nine miners. The driver of the van and the miner in the front seat were fatally injured. Of the remaining seven miners, one suffered a non-life threatening injury.
Best Practices
- When approaching large mobile equipment, do not proceed until you communicate and verify with the equipment operator your planned movement and location. Provide radio communication systems between vehicles and large mobile equipment.
- Ensure, by signal or other means, that all persons are clear before moving equipment.
- Minimize situations where smaller vehicles need to approach large haul trucks (e.g., arrange for haul truck drivers to have supplies available at the pre-shift meeting place, rather than delivering supplies to the truck).
- Do not drive or park smaller vehicles in a large truck’s potential path of movement.
- Equip smaller vehicles with flags or strobe lights positioned high enough to be seen from the cabs of haulage trucks.
- Install and maintain proximity detection or collision avoidance/warning systems and cameras.
Click here for: MSHA Preliminary Report (pdf), Final Report (pdf).
On October 17, 2017, a miner was fatally injured while operating a bulldozer on a downward slope. While pushing overburden to a rock bench below the top of the pit, he was ejected from the cab and run over by the left track. The machine continued to tram over the edge of the 58′ highwall.
On September 20, 2017, a contractor was fatally injured while rappelling within a conditioning tower. The victim was examining the inside of a 300’ vertical conditioning tower when an object fell from above and struck him in the head. The victim was conscious and transported to a local hospital where he died of his injuries the next day.
On September 5, 2017, a 20-year old plant operator with 23 weeks of experience was fatally injured at a sand and gravel mine. The victim was performing maintenance on a belt conveyor when he became entangled in the tail pulley.
On July 27, 2017, a miner was fatally injured when his light-duty truck was run over by a haul truck. The victim was pronounced dead at the scene.
On July 20, 2017, a miner was driving wedges into a block of granite in an attempt to break it loose. A piece of granite weighing 9 tons fell and crushed the victim against the quarry floor.
On July 14, 2017, a part time mine employee was moving irrigation pipe by hand and was electrocuted when the pipe came in contact with high voltage transmission lines overhead.
On June 8, 2017, a truck driver was operating a Caterpillar 777F haul truck, dumping a load of gravel, when the ground at the dump point collapsed. The truck went over the edge of the dump point, overturning and landing on its roof approximately 30 feet below. The victim was transported to the hospital, where he later died of his injuries.
On March 24, 2017, the victim exited his personal flatbed truck, which was left running in 6th gear, to turn off the genset (diesel generator). Prior to ascending the steps to the diesel generator, it appears the flatbed truck moved forward and pinned him against the genset trailer. The victim was found on Monday, March 27, 2017, and pronounced dead at the scene.
On March 14, 2017, an independent owner/operator truck driver, walked behind his raised end-dump trailer, while dumping his load and was engulfed by sand.